I have always been drawn to flying contraptions. The world of science fiction is full of quirky machines whose flying capabilities would be highly questionable, yet I found them immensely appealing. So, I decided to contribute my own grain of sand. It all began as a completely personal project, without much rhyme or reason. However, as I progressed, I could not help thinking in terms of individual reproducible parts, so that it could eventually be replicated as a complete model. I had to make some concessions to the design I originally had in mind and it ended up developing in what would become my second garage kit.

The preliminary concept was an antigravity vehicle with certain peculiarities. The inspiration came from old vintage race cars. A long body with smooth, streamlined shapes, featuring an external pilot at the rear in a reclined position, like a convertible. The front would be crowned with a large cooling grille. The sleek lines of the main body had to contrast with a more mechanically intricate lower and rear section, highlighted by a ridiculously large thruster and stabilizing fins, each with individual propulsion. Power was a must!

With this concept in mind, and after eight months of construction and development, the STEENBÖK you see here was born in the begining of 2023.

The model consists of 67 parts casted in high-quality polyurethane resin. Each piece is attached to a resin sprue, necessary for pouring the resin into the mold, which must be removed using a modeling saw. Each part is numbered for easy identification. Some key pieces are casted with a steel rod inside to enhance their strength and durability. Al parts fit in a very easy way and the construction process is very straightforward.

The kit includes an inventory of all parts, a step-by-step instruction manual, and a series of tips and tricks for building a resin model like this. Assembly is straightforward by following the manual's steps, although a thorough preliminary study is recommended. I always suggest using metal pins for joining key pieces or those that will bear some tension. The kit also includes a set of cables for additional detailing.

The model measures 22x17x18 cm and weighs approximately 450 g. The scale is 1:24. The model lacks any landing gear. It is recommended to use a stand to keep it in the desired position. Personally, I use two painted steel rods, each 2 mm thick, positioned at the front and rear sections

The model is fully paintable. I strongly recommend using a high-quality primer as a base coat.